Pull the thin, black carrier loop out of the coat until the carrier connection is visible.

Feed the thin, black carrier loop from the back to the front through the camera cut-out. If you have a case with a closed charging port, then you also guide the carrier loop through the opening of the speaker or charging cable.

Now thread the thick polyester ribbon including ribbon stopper through the carrier loop. To take full advantage of the thin carrier strap, make sure from now on that both carrier straps always lie flat next to each other, i.e. that they do not overlap and are not twisted.

Before tightening the phoneRope, slide the coat back over the carrier connection so that it disappears back into the coat. Continue to make sure that all the tapes are lying flat. Continue to make sure that all the tapes are lying flat.

Now pull the entire phoneRope tight so that it sits firmly on your case and fix it with the ribbon stopper. Tip: Generally keep the ribbon stopper pressed when moving it so that the polyester ribbon is not damaged. Put your phone back into the case as usual and you’re done!

Excellent suitable are cases with large lens cut-outs. When using precision-fit cutouts, the correct function must be checked on individual cases. Cases with the flash below the cutout are not suitable, as the flash could be covered by the phoneROPE.

The phoneROPE can be used on cases with open as well as closed connection areas.

For optimal handling, we recommend a stable smartphone case (e.g. hard cases made of hard plastic). Soft cases (e.g. made of silicone) are technically possible, but not recommended due to their instability. Please check for a secure hold before use.